nice

Azimuth projection lift.

Inground windmills. They make hills and adjust to dimensions of the tornados.  actuator raises and lowers the system. 

 
Going to have to Kansai some sections reverse feed. So if it goes over the settlement we generate by it pulling.  Aikido
















Gyroscope on Planetary gears?

or we can use the vortex itself to stire up the interior channel with the LC. Instead of the Planetary. We just have to setup the canards inside properly. Angle by rate of suction.  to create a vortex generator that uses kinetic energy through the crystaline.


So whirl pool tornado that generates a wormhole. We'll tie it to the geo sync system. See what information we can comprise from it.

 copper zinc cannards or whatever we use should vbe the static generator off the nkinetic friction. test time




Clintons Gott Arkansas and these fuckers are always playing  in your country anyway. Lets use Arkansa for the new test sites during tornados. I want that data. I need it for dust storms.


The data we accumlated already. How has the carprentries and the stone masonries perfected the art of building in relation to the Tornadoes?

Lets use the data we have and start practicing new building techniques towards the Tornadoes capabilities.

Wood has a way of dealing with this. Lets find it.



Hemp has twisitng techniques. So how do we make wood capapble of withstanding the suction of a storm while dealing with high wind intake?

Troubling. Hard to grasp, but we have data. We can do it. If anything we use the windature to the tornado with the building to feed back the geo data. I want this. I need this. We need this. As a collective. Not as a minority. We'll strive for this. To smart. Can't not do it.

When we find it. we make it state code. No other lumber allowed.


Okay so i have a concept.

W e to umbrella the alternator with gyroscopic motion. While using the data from the eletrical. So how are we going to use the Atmos ionis for the data sequence during the alternation?

 we need a camber kit inside the wall. and the flex of a steel cable fuel line. and we're going to have to take apart a torque gun

but remember we're dealing with pnuematics.

This ....is going to be hard.
 mix this combo with the new foundation and i think we got it.
we gotta judo it. Joint locking technique with aikido. I have to make a house 7 flow.

Nuts...

 ima have to make some new wood and zone the districts. we're going to need a new technique.

Trig time.


we're going to have to wankel the foundation gentlemen. planetary gears for the floorboards with a high tension rate.  Soft spring rate natural setting though?
we're going to have to leave abnormal spacer between wall and floor. So the floors going to stick out from the foundation. Kindof. going to have to figure out the data circuit.